Peugeot 405 Manual

Starter motor - removal and refitting
Starting and charging systems / Starter motor - removal and refitting


Removal
1 Disconnect the battery negative lead.

2 Disconnect the electrical connections to the starter motor (see illustration).

10.2 Unscrew the two nuts (arrowed) and disconnect the wiring from the rear
10.2 Unscrew the two nuts (arrowed) and disconnect the wiring from the rear of the starter motor

3 Where necessary, loosen the bolts securing the rear support bracket to the cylinder block (see illustration).

10.3 Starter support bracket bolts (arrowed) on an early model
10.3 Starter support bracket bolts (arrowed) on an early model

4 Where necessary, unscrew the nuts securing the rear of the starter motor to the support bracket.

5 Remove the bolts securing the starter motor to the gearbox housing (see illustration). Note the location of any brackets to ensure correct refitting.

10.5 Unscrew the starter motor securing bolts (1). Note the location of the
10.5 Unscrew the starter motor securing bolts (1). Note the location of the bracket (2)

6 Unclip the crankcase breather hose from the bracket.

7 Swing the bracket rearward, then manoeuvre the starter motor from the engine.

Refitting
8 Refitting is a reversal of the removal procedure.


© 2018 www.peugeot405.ru. All Rights Reserved.