Peugeot 405 Manual

Oil temperature sensor - removal and refitting
Starting and charging systems / Oil temperature sensor - removal and refitting


Removal
1 The oil temperature sensor is screwed into the sump (see illustration).

15.1 The oil temperature sensor is screwed into the sump
15.1 The oil temperature sensor is screwed into the sump

2 To gain access to the sensor, firmly apply the handbrake then jack up the front of the vehicle and support it on axle stands (see УJacking and Vehicle SupportФ).

3 Drain the engine oil into a clean container then refit the drain plug and tighten it to the specified torque setting (see Chapter 1).

4 Disconnect the wiring connector then unscrew the sensor from the sump, and remove it from underneath the vehicle along with its sealing washer.

Refitting
5 Examine the sealing washer for signs of damage or deterioration and if necessary renew.

6 Refit the sensor, tightening it securely, and reconnect the wiring connector.

7 Lower the vehicle to the ground and refill the engine with oil as described in Chapter 1.


© 2018 www.peugeot405.ru. All Rights Reserved.