Peugeot 405 Manual

Ignition system amplifier unit(s) - removal and refitting
Ignition system / Ignition system amplifier unit(s) - removal and refitting


Removal
1 Disconnect the battery negative terminal.

Breakerless ignition system 2 The amplifier unit is mounted onto the side of the distributor body (see illustration). To improve access to the unit, disengage the hot air inlet hose from the control valve and manifold shroud and remove it from the vehicle.

5.2 On breakerless ignition systems the amplifier unit is mounted on the side
5.2 On breakerless ignition systems the amplifier unit is mounted on the side of the distributor body

3 Disconnect the wiring connector then undo the two retaining screws and remove the amplifier unit.

Integral ignition system 4 The amplifier unit is located in the righthand rear corner of the engine compartment.

5 To remove the unit, disconnect the wiring connector, undo the two retaining screws and remove the amplifier from its mounting bracket.

Direct ignition system
6 Both amplifier units are located on a bracket situated in the left-hand rear corner of the engine compartment, to the rear of the battery.

7 To remove either unit, disconnect the wiring connector, undo the two retaining screws and remove the amplifier unit from its mounting bracket.

Refitting
8 Refitting is a reversal of the removal procedure.


© 2018 www.peugeot405.ru. All Rights Reserved.