Peugeot 405 Manual

Front bumper - removal and refitting
Bodywork and fittings / Front bumper - removal and refitting


Removal
1 Working at the bottom of the bumper, remove the three lower bumper securing screws (see illustration).

6.1 Front bumper lower securing screw
6.1 Front bumper lower securing screw

2 Working on one side of the vehicle, remove the three screws securing the outer edge of the wheel arch liner, then pull the liner back from the bumper.

3 Unscrew the two bumper front securing nuts (see illustration).

6.3 Front bumper front securing nuts (arrowed)
6.3 Front bumper front securing nuts (arrowed)

4 Unscrew the bolt securing the side of the bumper to the wing panel (see illustration).

6.4 Front bumper side securing bolt (arrowed)
6.4 Front bumper side securing bolt (arrowed)

5 Repeat the procedure in paragraphs 2 to 4 on the remaining side of the vehicle.

6 Pull the bumper forwards and, where applicable, disconnect the front foglight wiring harness and/or the headlight washer fluid hose. Note the routing of the wiring and/or hose.

7 Remove the bumper.

Refitting
8 Refitting is a reversal of removal but, where applicable, ensure that the foglight wiring and/or washer fluid hose are correctly routed.


© 2018 www.peugeot405.ru. All Rights Reserved.