Peugeot 405 Manual

Boot lid lock components (Saloon models) - removal and refitting
Bodywork and fittings / Boot lid lock components (Saloon models) - removal and refitting


Boot lid lock cylinder Note: New pop-rivets will be required to refit the body rear trim panel, and on some models the lock cylinder.

Removal
1 Open the boot lid.

2 Pull the weatherseals from the edge of the rear luggage compartment trim panel, then carefully pull the trim panel from the upper edge of the luggage compartment.

3 Drill out the securing rivets from the top of the body rear trim panel, then unclip the trim panel and withdraw it from the rear of the vehicle (see illustration).

17.3 Drill out the rivets (arrowed) from the body rear trim panel
17.3 Drill out the rivets (arrowed) from the body rear trim panel

4 Working in the luggage compartment, where applicable unscrew the pinch-bolt, and disconnect the operating rod from the lock cylinder (see illustration). Similarly, disconnect the central locking motor rod, where applicable.

17.4 Unscrew the lock operating rod pinch-bolt (arrowed)
17.4 Unscrew the lock operating rod pinch-bolt (arrowed)

5 Drill out the rivets, or unscrew the securing bolts, as applicable, and withdraw the lock cylinder from the body panel.

Refitting
6 Refitting is a reversal of removal, bearing in mind the following points.

a) Refit the body rear trim panel (and the lock cylinder, where applicable) using new pop-rivets.

b) Check the operation of the lock mechanism before refitting the trim panels.

c) If necessary, on models where the operating rod is secured to the lock cylinder with a pinch-bolt, adjust the rod as necessary (by slackening the pinchbolt) until the lock operation is satisfactory.

Boot lid lock
Removal
7 Proceed as described in paragraphs 1 and 2.

8 Unscrew the two securing bolts, then withdraw the lock and disconnect the operating rod.

Refitting
9 Refitting is a reversal of removal, but check the operation of the lock before refitting the trim panel.

Boot lid lock striker
10 The striker is secured to the boot lid by two bolts, and can be adjusted by moving it within the elongated bolt holes.


© 2018 www.peugeot405.ru. All Rights Reserved.