Peugeot 405 Manual

Instrument panel components - removal and refitting
Body electrical system / Instrument panel components - removal and refitting


General
1 Remove the instrument panel as described in Section 9, then proceed as described under the relevant sub-heading.

Gauges - models up to 1992 2 Release the securing clips, and unscrew the three securing screws, then remove the panel surround/lens assembly from the instrument panel.

3 Unscrew the relevant securing screws or nuts, then withdraw the gauge from the front of the panel.

4 Refitting is a reversal of removal.

Gauges - models from 1993 5 Working at the rear of the panel, remove the lens securing screws from around the edge of the panel (see illustration).

10.5 Two of the instrument panel lens securing screws (arrowed)
10.5 Two of the instrument panel lens securing screws (arrowed)

6 Remove the two recessed lens securing screws from the rear of the panel (see illustration).

10.6 Remove the two recessed lens securing screws
10.6 Remove the two recessed lens securing screws

7 Release the securing clips by carefully prising with a screwdriver, then withdraw the lens assembly.

8 Where necessary, for access to the gauge fixings at the rear of the gauge, remove the screws and withdraw the cover from the rear of the instrument panel (see illustration).

10.8 Removing the cover from the rear of the instrument panel
10.8 Removing the cover from the rear of the instrument panel

10.9 Fuel gauge securing nuts (arrowed)
10.9 Fuel gauge securing nuts (arrowed)

9 Unscrew the nuts from the gauge contact studs, or remove the gauge securing screws, as applicable (see illustration).

10 Where applicable, working at the front of the gauge, remove the gauge securing screws (see illustration).

11 Carefully withdraw the gauge from the front of the instrument panel, taking care not to damage the circuit board. Where applicable, recover the spacers from the gauge studs (see illustrations).

12 Refitting is a reversal of removal. Make sure that the spacers are in position on the gauge studs, where applicable.

Illumination and
warning light bulbs
13 Twist the relevant bulbholder anticlockwise to release it from the rear of the panel. The bulbs are integral with the bulbholders.


© 2018 www.peugeot405.ru. All Rights Reserved.