Peugeot 405 Manual

Radio aerial - removal and refitting
Body electrical system / Radio aerial - removal and refitting


Roof-mounted aerial
1 Note that the aerial mast can simply be unscrewed from the base. To remove the complete aerial assembly, proceed as follows.

2 Disconnect the battery negative lead.

3 Unclip the sun visors from the roof console.

4 Carefully prise the courtesy light assembly from the console to expose the two roof console front securing screws. Disconnect the wiring plug and remove the light.

5 Similarly, prise the map reading light an the light surround from the console to expose one of the front securing screws. Disconnect the wiring plug and remove the light.

6 Prise the blanking plate from the console then, where applicable, push the sunroof switch from the console.

7 Remove the two console screws exposed by removal of the map reading light and sunroof switch, then lower the console from the roof, and disconnect the wiring plugs.

8 Prise the metal insulator from the base of the aerial (see illustration).

22.8 Roof-mounted radio aerial metal insulator (arrowed)
22.8 Roof-mounted radio aerial metal insulator (arrowed)

9 Unscrew the securing nut and disconnect the aerial lead, then withdraw the aerial from the top of the roof.

10 Refitting is a reversal of removal.

Rear wing-mounted aerial Saloon models
11 Fully retract the aerial.

12 Working in the luggage compartment, remove the trim panels from the left-hand side of the wing panel.

13 Disconnect the aerial lead connector and the earth wire from the bottom of the aerial (see illustration). On models with an electric aerial, disconnect the motor wiring plug.

22.13 Aerial lead (A) and earth wire (B) - Saloon (rear wing-mounted manual
22.13 Aerial lead (A) and earth wire (B) - Saloon (rear wing-mounted manual aerial)

14 Unscrew the aerial mounting bracket lower fixing bolt.

15 Working at the top of the aerial, unscrew the ring nut securing the assembly to the top of the rear wing. Recover the sealing grommet (see illustrations).

22.15a Unscrew the ring nut . . .
22.15a Unscrew the ring nut . . .

22.15b . . . and recover sealing grommet - Saloon (rear wing-mounted manual
22.15b . . . and recover sealing grommet - Saloon (rear wing-mounted manual aerial)

16 Withdraw the aerial assembly down into the luggage compartment.

17 Refitting is a reversal of removal.

Estate models
18 The procedure is as described previously for Saloon models, but the upper end of the aerial is retained by a grommet arrangement instead of a ring nut. When removing the aerial, simply pull the top of the aerial down through the grommet (see illustrations).

22.18a Disconnecting aerial motor wiring plug - Estate (rear wing-mounted
22.18a Disconnecting aerial motor wiring plug - Estate (rear wing-mounted aerial)

22.18b Unscrew the aerial motor securing bolt . . .
22.18b Unscrew the aerial motor securing bolt . . .

22.18c . . . and withdraw aerial assembly - Estate (rear wing-mounted aerial)
22.18c . . . and withdraw aerial assembly - Estate (rear wing-mounted aerial)


© 2018 www.peugeot405.ru. All Rights Reserved.